GENERAL HANGING INSTRUCTIONS

• Always use a new blade for each cut.
• Do not double cut.
• Use high quality clear hanging paste.
• Always apply an even coat of paste to either the back of the wallcovering or directly on the wall. Never saturate the wallcovering with paste.
• Make sure your hands and tools are always clean.
• Begin at the top left corner. Set top to hold while securing the corner edge.
  Smooth air bubbles out from top to bottom using a smooth trowel.
• Do not stretch or overwork seams.
• Never use pen or marker to mark up walls or wallcovering.
• Care should be taken to avoid adhesive touching the face of the wallcovering.
• Always make sure the wall you are hanging on has had all other wallcovering, wallplates and obstructions removed. Walls must be smooth, structurally sound, dry, sealed and clean. Repair any holes and cracks, and sand smooth.
• Prime the wall the same color as the wallcovering.
• It is very important not to crease the wallcovering during installation.
• Always use non-stick tape.
• Always paste out toward edges.
• Liners are always recommended and help with reducing wallcovering shrinkage.
• After installing a maximum of three panels, inspect application. If satisfactory, continue. If not, discontinue and contact Bergamo.

NOTE
The manufacture assumes no responsibility for installation of material beyond
three panels and will not be held responsible for labor under any circumstances.