
You need The latest Flash Player and javascript enabled to see this content.
- Always make sure the wall you are hanging on has had all other wallcovering, wallplates and obstructions removed. Walls must be smooth, structurally sound, dry, and clean.
Repair any holes and cracks, and sand smooth. - Make sure your hands and tools are always clean.
- We highly recommend priming and lining walls before installing wallcovering.
- Do not hang directly on an oil based primer.
- Always use a new blade for each cut.
- Always use non-stick white tape.
- Use high quality clear hanging paste with “mildew system wallpaper adhesive.”
Paste should not be watered down. - Always apply an even coat of paste to either the back of the wallcovering or directly on the wall.
Never saturate the wallcovering with paste. Paste out toward edges. - Double cut installation is not mandatory. Installing method should be left up to your professional installer. For a list of professional installers near you please visit www.ngpp.org
- It is very important not to crease the wallcovering. Avoid touching the face of the wallcovering.
- Begin at the top left corner. Set top to hold while securing the corner edge.
Smooth air bubbles out from top to bottom using a soft brush. - Do not stretch or overwork seams.
- After installing a maximum of three panels, inspect application. If satisfactory, continue.
If not, discontinue and contact Weitzner customer service at 888.609.5551.
NOTE
The manufacturer assumes no responsibility for installation of material beyond three panels and will not be held responsible for labor under any circumstances.
Its hand-gilded finish makes a striking statement when laid over a painted wall to let the color beneath show through the apertures. Oracle might also create a one-of-a-kind room divider if hung from the ceiling or placed between sheets of glass.
Please note: The visible seaming on this product is not a manufacturing defect. Splicing several panels together is necessary to create a continuous roll.

Piece length up to approximately 3 yards
Trim sheet dry on the table.
Paste the back of the sheet with a good amount of paste but do not saturate the wallcovering.
When hanging the wallcovering make sure to use a soft brush to lay down the wallcovering. Be sure to keep an eye on the wallcovering and keep using the brush to lay it down to ensure it will not pucker.
Clean off your table and tools from any glue before cutting and hanging the other sheets to avoid removing color. Always use clean water.
Avoid adding too much moisture to this product.
If you oversaturate, you risk the color of the wallcovering changing to a pinkish hue.
DO NOT RUB.
Normal, regular vacuuming with a soft brush attachment may be used to remove dust deposits.
This product may not match up at the seams.
This is tree bark, a natural product that is inconsistent by nature. Please note that treatments can vary greatly.
Splicing is necessary in order to make a continuous roll of 3 yards. Please note the spliced areas and hang randomly.
Not guaranteed against fading or color change. Avoid direct or brilliantly reflected sunlight.
Hospitality Product Design Award, IIDA/Hospitality Design Magazine, The MASTERWORKS Collection - Oracle, 2007
To open an account, please contact Customer Service below.











